Ads by Google
2012 hot selling mesh belt drying machine
Model | Diameter(m) | Effective drying length(m) | Width(m) | Equipped with reducer Model | Equipped with the motor model | Equipped with the motor powder(kw) | Yield(T/h) |
20m*3L | 21.27*2.44*3.016 | 20 | 1.9 | BWEYCT 7.5-74-235 | YCT200-4B | 7.5 | 6-10 |
40m*3L | 42.35*2.44*3.016 | 40 | 1.9 | BWEYCT 11-74-187 | YCT225-4A | 11 | 12-16 |
principle
the mesh belt drying machine is continuous drying equipment , suitable for well ventilation property strip, slice, grain material drying, more suitable for dehydration vegetable, chinese traditional medicine which contain much moisture, and not allowed high temperature. This dryer drying speed is fast, evaporate moisture is high and quality is good.
principle as seen,material in the hopper put even on the stainless steel silk screen, mesh belt even pace move in the dryer drive by transmission motor. drying section make up by some units, hot wind landscape orientation circle in the two units, fresh air enter into from fan (1), heat by heat exchanger, hot air pass through material layer and exchange with material, enter into under casa, then flow to next unit, after the temperature reduction hot air through heat exchanger again to heat second, hot air penetrate mesh ble and heat exchange with material second, hot air penetrate mesh belt and heat exchange with material, wet material discharge by wet fan (2)(5), complete the drying. each dryer unit quantity can choose by material characteristic, craft requirements.principle fo work
Sale promise of the mesh belt drying machine
Before sale:
(1) Selection of equipment type.
(2) Design and manufacture products according to the special requirement of customers.
(3) Training technical personnel for customers
(4) Send technicians freely to users for site planning, optimal design process and scheme.
During sale:
(1) Acceptance check of products.
(2) Assist customers in drafting construction plan.
After sale:
(1) Appoint specialized aftersale service staff to users for installation and debugging.
(2) Install and debug the equipment.
(3) Train operating personnel.