Ads by Google
What is the tirepressuer smart cap TP03?
TP02 is a innovative Tire Pressure Smart Caps which would show the vehicle tires status by blinking RED o not. It features its extremly high accuracy, visibiity, economical cost comparing to other TPMS on the market. It's a must for your vehicles and fleet management.
Special Features:
•Blinking red as alarm if tire pressure is lower than precalibrated value
•Tire Pressure value can be resettable
•Battery Replaceable
•Universal for most vehicles: Cars and Trucks
•Waterproof and Air Tightness
•Anti-theft Design
Technical properties:
• accuracy: +- 1.5psi
• range: 10psi--300psi
• Anti-theft Design
• Stainless Steel, Waterproof , Air Tightness
• Alkaline Button Cell: 1.5V. blinking continuously 3 weeks.
• 2 -3 years for standby use.
Benefit from this device:
• Extend the life of the tire.
• Save your fuel consumption.
• Control the tire pressure constantly.
• Release your attention from tire and more safety.
• No more tire break-ups due to running tires under inflated.
How to use it:Make sure your tire is ok.
1. Using keys supplied, remove the top battery cover then slide off the anti-theft sleeve: place Metal key at the bottom of sensor then place Plastic key over the LED and rotate anti-clockwise.
2. Remove batteries and cover, to calibrate and memorise the tire pressure, firstly insert Metal key into the sensor like shown below and rotate then centre(hexagon) part of the sensor anti-clockwise until it stops rotating. It’s for releasing the old memory.
3. Now screw the sensor onto the tires valve stem, insert Metal key and rotate the centre (hexagon) clockwise until it stops turning. This stores the tire’s pressure value into memory.
4. Unscrew the memory part, asseble them again with keys. And install it onto stem of tire with plastic key.
5. The tire pressure alarm flasher doesn't blink if the tire pressure is ok. It blinks RED if the tire pressure is lower than pre-calibrate value
To test the sensor is working, fit the batteries and battery cover to the sensor then unscrew the sensor from the valve stem. As soon as the sensor is removed, the red LED will begin flashing. If the LED doesn't flash once the sensor is removed, please check the batteries are inserted correctly or repeat stops 2 and 3.
We suggest that you should inflate tires after you calibrate sensors. For example, if you want tire pressure sensor to blink at 30psi, you should calibrate the sensor at 30psi, secondly inflate tire to 31psi or higher. During use, if pressure drops to about 30psi or so, it would start to blink as alarm.
Company Profile:
Totem is focusing on GPS tracking system and Tire Pressure Monitoring System these years. With our experienced hardware design on Atmel MCU / STM32 MCU, and the good power management for unstable voltage output, Our GPS tracking system provides location, Speed, heading direction, time, GPS signal accuracy, fuel level data, GSM cell ID, mileage, door open/close status, unlimited history, engine on/off status, routing, and messaging all immediately available if any interrupts or alerts happen. With a wide range of customized reports, alerts, it can bring you the better improvement of productivity, expenses reduction, extend the life of the vehicles, etc.
We are also the manufacturer and designer of Tire Pressure Monitoring System (TPMS) products. Comparing with the current TPMS products on market, we offer an economical and convenient TPMS other than current TPMS products which is hard installing and costive.