Its overall dimensions are: - Length: 2400 mm; - width: 1,000 mm; - height: 1,000 mm; - diagonally across the base: 2600

GENERAL FEATURES Tent 100% waterproof and consists of: ground cover and, up roof, hinged frame (arcs), spikes and carrying case. Once assembled, the tent must not contain gaps, folds or wrinkles in walls and doors. Consequently, the tissues of the tent body, doors and up Roof should be fully stretched when the tent is assembled. Must withstand winds of up to 65 km / h.

Its overall dimensions are: - Length: 2400 mm; - width: 1,000 mm; - height: 1,000 mm; - diagonally across the base: 2600 mm.

3.1 Tent BodyThe tent body is made up of:- Floor made of lightweight canvas, shaped like a rectangle 2400 mm x1000 mm 150 mm bottom contour around the tent (Fig. 1 and 2) and- Walls made of woven nylon, attached to the bottom of tent.In one of the side walls (width), there will be an oval port, containing a displaymosquito screen, and closed by zipper with double slider.At the top of the opposite side, is applied to a narrow band of fabricmosquito and, in the middle, a circular shield, also in mosquito screen.The remaining walls (narrow) have indentations on mosquito screen, set theof polyamide, and shaped like a diamond.On the outside of the tent, near the junction of the upper arches, will be fixedtogether with the seams joining the panels, made up of four channelsnylon fabric, each measuring 300 mm in length and 70 mm highfor containment of the arches.In union with the bottom and the middle part of the seams joining the walls will befixed cleats, made with textile belts and plastic seals, designed tofixing the cover to the arcs.The setting of the tent to the ground is made of nylon webbing for six 25 mmwidth, 110 mm long, four straps attached at the corners of the tent andat the center of two sides, one on each side, attached by sewing all type travete.On the free end of these straps is fixed equilateral triangle, plasticinjected, through which passes the stanchion. The belts still need an eyelet 8 mminner diameter, set at 70 mm from the apex of the tent, for placing the tip ofarches of the frame.Once armed, the tent should make the walls straight, freekinks or bends.All measurements are referenced above the finished product.Tent seams are sealed with silicone or tape 100% polymethylmethacrylate.

military tent