H700 Molded Plastic Manometer

Make sure the oil being used is for the correct manometer.

Installation: Position manometer on a vertical surface. Drill two 1/8” or 9/64” holes on a vertical line 315/6” aprt. Loosely mount manometer with self-tapping screws provided. Adjust gage until level bubble is centered in level vial,then secure the manometer tightly.

Air Filter Gage

Mount gage within 3ft. of filter bank. Install tubing adapters on each side of filter. Run tubing from clean side of filter to positive pressure side of gage ( left fitting). Run downstream side to low pressure side of gage(right fitting). Install green and red arrows adjacent to indicating tube to indicate filter condition.

H700 Molded Plastic Manometer