LED Street Light Solar controller Good quality High-advance technology Intelligent Contol Timing Function, Weatherproof Specifications

60A 12V/24V PWM Intelligent Solar Controller / Regulator LCD Display Temperature Compensation Identification System Voltage

60A 12V/24V PWM Intelligent Solar Controller / Regulator with LCD Display, Communication Port, Temperature Compensation

1. Product Introduction

CM series controller is a kind of intelligent, multi-purpose solar charge and discharge controller. The family use the fixed LCD display, with a very friendly interface; various control parameters can be flexibly set, fully meet your various application requirements. CM series controller has following features:

*Image of LCD graphic symbol

*Simple button operation

*Automatic Identification System Voltage level

*Intelligent PWM charge mode

*Automatic Temperature Compensation

*Adjustable charge-discharge control parameters

*Settable Operating mode of Load

*Accumulated function of charge and discharge Ampere hours

*Remote monitoring and control function (custom)

*Battery reverse-discharge protection

*Battery Low Voltage Disconnection (LVD)

*Battery reverse connection protection

*Overload, Short Circuit Protection

2, Install:

1. Ready tools and cables. Encourage you to matching the right cables. Ensure that the current density <4mm2

that is conductive to reducing the line voltage drop. Recommended: 30A with 10mm² cable. Check weather the installation sites compliance with the relevant safety requirements. Please avoid the damp, dusty, there is a place flammable, explosive and corrosive gases use the controller to install.

2. Install the controller into a fixed vertical plane. See section 5 of the pore size and pore spacing. In order to ensure a good thermal control conditions, please set aside each 10cm below the controller space.

3. As shown on the right, connect the (1) Load, (2) Battery and (3) Solar Panel to the controller according to the order of (1) (2) (3). Pay attention to the load, battery, solar panel and controller of same polarity.

4. Put into the external temperature sensor on the left of the controller (probe port). The temperature sensor should be similar space with battery. (Otherwise, the controller will control the parameters of all wrong temperature compensation.)

5. If you have remote monitoring and control function, please insert one end of the included communication wire on the right of the controller (communication port), the other end to connect to the host computer.

Demolition: To prevent accidents, please order the demolition of solar panels, battery and load disconnect with controller.

Note:Battery polarity will not damage the controller, but you will have a load equipment security risks.

3, Technical Data

Model	CM6024Z	MODEL	CM6024Z
RATED OPERATION CURRENT	60A	WIRE SIZE	less than 3# AWG (25mm2)
RATED OPERATIONAL VOLTAGE	12V/24V	WORK TEMPERATURE	-20°c~50°c
SOLAR PANEL VOLTAGE	less than 50V	STORAGE TEMPERATURE	-30°c~70°c
FLOAT VOLTAGE	13.7V/27.4V	HUMIDITY REQUIREMENT	less than 90%, NO CONDENSATION
LOW-VOLTAGE PROTECTION	10.7V/21.4V	SIZE	130mm×188mm×62mm
LOW-VOLTAGE RECOVER	12.6V/25.2V	INSTALLATION HOLES DISTANCE	98 mm×178 mm --Φ5
OPEN CIRCUIT LOSS	≤30mA	WEIGHT	590g
RETURN CIRCUIT VOLTAGE	≤200mV
CHARGE MODEL	PWM
TEMPERATURE COMPENSATION	-4mV/Cell/°c
MARK	“Z” mean voltage class automatic recognition