Mining Under Suction Submersible Water Pump
This pump is widely used for the irrigation for agricultural land, the water supply and sewage for industrial and mining enterprises, and the water utilization for the people and animals in altiplano and mountain area.
1. Working Parameters
(1). Flow range 10-500m³/h
(2). Lift range 10-600m
(3).Caliber range:32-203mm
(4).Temperature:-15~80 degree
2. Product Overview
The self-cooled, high-lift and downdraft suction type pumps adopt water-filled wet type well use submersible motor,
the empty cavity between the motor shell and the protect tube is used as water channel, which can make the motor get sufficient cooling, and also make the submersible pumps have good cooling conditions, long servise life, high efficiency, simple structure and low cost.
This national patent, tube protect and downdraft suction type pumps with high power, big flow, high-lift are designed
especially for rescuing drainage under coal well. It can drain the mine water away completely . Furthermore, it has
reasonable structure, high efficiency . In addition, it is energy saving, convient to assemble and maintain, reliable to
use, etc.
3. model signification
300 QJ 300-160
160--------------Lift (m)
300 -------------Flow (m3/h)
QJ --------------Well use submersible pump
300--------------Base No.
4. use conditions
(1). Voltage 380V, allowable variation ±5%, frequency 50HZ, three-phrase power source with an allowable variation
of ±1%
(2). The inner cavity of the Motor must be filled with water.
(3). The first stage impeller of the pump should be immersed into the the dynamic water level at least 2 m. And the
electric pump nuit under the static water level should be within 70 m.
(4). The distance between the bottom of the motor and the botom of the well should not be less than 3 m.
(5). The temperature of the water should be within 20°C.
(6). In the water, there are only 0.01% of sand by weight or less could be contented.
(7). The PH value of the water should should be between 6.5 and 8.5.
(8). The hydrogen sulphide level in the water should be 1.5mg/L or less.
(9). The chloride ions content in the water should be 400mg/L or less.
(10). Water which is yield from the water source should meet the necessary of the pump's continue work.
5.Material:
Impeller:Cast iron HT200,or stainless steel
Pump bowl:Cast iron HT200,or stainless steel,such as ss304 ss3016
Pump shaft :Cold-drawn steel with chrome plating,or stainless steel ss304 ss316
Motor Seal:Rubber O-ring seal,mechanical seal
Motor regulating sleeve:rubber
6.Characteristics
Motors and pumps assembled into one.
Simple structure.
Easy installation and removal, small area.
Simple using and maintenance.
Safe and reliable operation, no pollution to water, etc.
Calibration Console