Clamp force:98 ton with Variable Pump Shot weight 116-182 gram Oil temperature of system is reduced largely

Main specification of HXW98 variable pump		Screw A	Screw B	Screw C	Screw D
Injection Unit
Screw Diameter	mm	32	35	38	40
Screw L/D Ratio	L/D	24	22	20.2	19.2
Shot Volume (theoretical)	CM³	128	154	181	200
Injection Weight (PS)	g	116	140	164	182
	oz	4.0	4.9	5.7	6.4
Injection Rate	g/s	71	85	101	111
Plasticizing Capacity	g/s	10	11	13	17
Injection Pressure	MPa	262	219	185	168
Screw Speed	rpm	200
Clamping Unit
Clamp Force	KN	980
Toggle Stroke	mm	315
Max. Mold Height	mm	390
Min. Mold Height	mm	150
Space Between Tie Bars (W×H)	mm	360X340
Ejector Force	KN	43
Ejector Stroke	mm	100
Ejector Numbers	n	5
Others
Max Pump Pressure	MPa	16
Pump Motor Power	kW	11(9.5)
Heater Power	kW	8.1
Machine Dimension (L×W×H)	m	4.16×1.19×1.76
Machine Weight	t	3.0
Oil tank capacity	L	203

  

Standard equipment:

1) Double cylinder balancing injections2) High-torque oil-motor preplasticizing3) Five pivots minus relief angle, double toggles, machine hinge mold locking4) Cabinet-type holder integrates the mold plate5) Oil motor driven gear mold adjusting6) Storage-type grease lubricating7) Pressure and flow whole-proportion running8) High-performance, low-noise oil pump9) Multi-step pressure and speed adjusting10) High-precision position linear transducer11) Digital memory for mold groupInjection unit: 1) Four injection pressures and speeds with three additional pressures and speeds2) Suck back function3) Cold start protection4) Pre-suck back function5) Linear displacement transducer accurately monitor injection position, providing optimum. injection accuracy and control6) Temperature control7) Heating Status indicationClamping unit: 1) Three clamp close and open pressures and speeds2) Mold protection function3) Hydraulic ejector stroke controlled by transducer4) Automatic hydraulic die-height adjustment driven by planetary gears system5) Adjustable support under moving platen6) Automatic high pressure toggle lubrication with low oil level alarm7) Mechanical, electrical and hydraulic safety interlock devices8) Linear displacement transducer controls clamping positionOther parts: 1) Independent core in / out pressure and speed2) Hydraulic unscrewing sequence3) Hydraulic oil high temperature alarm4) System pressure gauge5) Shot counter and reset function6) Malfunction alarm light7) Self-diagnostic function8) Emergency stop buttons placed both front and rear of the machine to provide easy access

HXW98 Plastic Injection Moulding Machine