Capacity: 3200-4000pcs/hr (based on 500ml) Max volume of product: 2 liters

Automatic PET Bottle Blow Moulding Machine

Main part:
Pneumatic part	Valve	Feston
	Cylinder
Electric part	PLC	Mitsubishi
	Operating system	LG /HITECH
	Relay	OMRON
	Infrared thermometer	America raytek
Note	All of the electrical components adopts CEULCCC approved international advanced high-tech product.
Main parameter:
Model	GSA4
Productivity	Depend on bottle design	3200-4000PCS/H
Product type	Body diameter	20mm-100mm
	Height	50mm-350mm
	Neck diameter	15mm-38mm
Mold	Cavity	4cavities
	Mold thick	240mm
	Mold	500*500mm
Main machine power	Electrical source power	380v 3Phase /220v 3Phase  50/60HZ
	Rated Power	49kw
	Really use power	14kw
Air source	LP air compressor	1.6m3/min 1.0MPa 1set (15KW)
	HP air compressor	1.0m3/min 3.0MPa 2sets (each set 11KW)
	Air dryer	2.0m3/min 3.0MPa 1set
Cooling water	Cooling water	15L/min
Size	L*W*H	1908*1858*1920mm
	Weight	3600kg
Auxiliary equipmentpreform unscrambler	L*W*H	276*106*186mm
	Weight	250kg
Resin available		PET

  

GSA4 Full automatic blow molding machine is suitable for producing PET plastic containers and bottles in all shapes. It is widely used to produce the carbonated bottle, mineral water, pesticide bottle oil bottle cosmetics, wide-mouth bottle and hot fill bottle etc.

Features of main body:

1). Stable performance with advanced PLC.

2). Automatic preform conveyer to save human cost.

3). Preform self-rotation and infrared pre-heater revolution assure the even distribution of heat, which improve the bottle shaping rate, increase the production.

4). High adjusting performance to enable preheat the preforms perfectly by adjust the voltage control area in the PLC, which could adjust the temperature of the infrared lights in the pre-heater, and keep the proper temperature and humidity invariable.

5). High safeties with security automatic-locking device in each mechanical action, which will make the production into a perfect safe environment, in case of the breakdown in certain procedure.

6). Introduce the FESTO air cylinder to avoid contamination and noise.

7). Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine.

8). Strong clamping force with high pressure and double crank links to lock the mould.

9). Two ways of operating: automatic and manual.

10). Safe,reliable and unique design of the position of valve to make the pneumatic diagram in the machine easier to understand.

11). Low cost,high efficiency,easy operation and maintenance etc, profited from the fully automatic technological process.

12). Ideal cooling system make the finished bottles without any flaws.

13). Easy for you to install,test and start up.

14). Low rejection rate: less than 0.2 percent.

Automatic Blow Moulding Machine GSA4