New mould camera.Injection moulded. No screws. PP plastic 1mm thick plastic so that it does not break.2 colours of plastic, 1 colour for main section and the push button, the other colour for the moulded face section. Colours of plastic can not be mixed.Main section to have 1 colour paint on the front which will be silver as per existing camera seen in image "12479 Camera & stickers" which has a similar design. Silver section will be on a slightly raised section size approx 14mm x 20mm.On the raised section to the side of the camera we would like to have 2 buttons 10mm diameter similar to the previous camera seen in image "12479 Camera & stickers we would like these 2 buttons to also be painted silver. Moulded face section to have 3 colours of paint on top.A tunnel like the previous camera order will be part of the main section. there will be a hole through the face section as per the attached image also to look through. 1 x CMYK printed sticker on the back of the camera with out lamination. Size with in 5cm x 4cm. rectangle with rounded corners.Face sections size 95mm high x 78mm wide x 5mm deep. Main section size 10mm high x 120mm wide x 25mm deep.Over all size 10mm high x 120mm wide x 25mm deep. weight approx 36g 4 x Chunky Wax Crayons, 110mm high x 11mm diameter, CMYK printed paper wrap. Same wrap for each crayon, different wax pantone matched for each crayon. In OPP poly bag. 1x CMYK printed paper sticker sheet with out lamination. Size 12cm x 10cm.Kiss cut |
FACE CAMERA SET (AF12965)