1. IXP1200 Processor 2. Gigabit or Fast Ethernet (100M/1000M) 3. IX Bus / slow port 114-pin 4. PCI Mezzanine connector

FIDS12MC1 – NPU Base Card

The FIDS12MC1 Network Processor Base Card occupies two 6U slots within the cPCI system. It includes a 200 MHz IXP1200 network processor with 66 MHz IX Bus and a memory subsystem consisting of 8 Mbytes of flash memory (up to 64M), 6 Mbytes of SSRAM, and 128 Mbytes of SDRAM (up to 256M). Other components include a PP1200 stream classifier, a 2Mb TCAM, an Intel 21555 Non-Transparent PCI-to-PCI bridge chip, and an Intel 82559 Fast Ethernet chip.

The front-panel features:

1.Two Gigabit Ethernet connectors2.One 10/100 RJ-45 Ethernet connector for the PCI/Ethernet interface3.Eight 10/100 RJ-45 Ethernet connectors, or Two Giga Ethernet ports4.One RS232 9-pin D-sub serial port connector5.One recessed master reset switch6.Green/Red- Pass/Fail indicator LEDs

The board features: 

1.Two IX Bus/slow port 114-pin connectors2.Two PCI Mezzanine connectors3.One SDRAM debug connector (three 38-pin Mictor connectors)4.One SSRAM debug connectors5.Power connector for standalone application without CPCI interface used 

The interface to the Compact-PCI back-plane is via two standard cPCI connectors (J1, J2) providing a standard 64-bit bus at speeds up to 66 MHz.

FIDS12CC1 – FE/GE interface cardIncluding an Intel IXF440 Dual-Speed Multi-port Ethernet MAC and Intel IXF1002 Dual-Port Gigabit Ethernet MAC, providing eight 10BASE-T or 100BASE-T connections and 2 GE connections.

FIDS12CC2 – GE/POS interface cardIncluding an Intel IXF1002 Dual-Port Gigabit Ethernet MAC and an Agilent PM5351, providing two GE interface and four 155M interface

IXP1200 Multi-Service Network Platform device