Ads by Google
Specifications:
Application: | CR/HRC/stainless steel /galvanized and so on |
thickness of coil plate: | 0.1-1mm |
width of coil plate: | 500mm |
coil weight: | 1000kg |
coil I.D: | 508 |
coil O.D: | 1000mm |
the diameter of slitting blade shaft | 100 |
slitting blade: | 100X200X10 |
material of slitting blade: | 9CrSi |
the hardness of slitting blade: | HRC58°-60° |
recoiler I.D: | 508 |
power: | 380V/50Hz/3Ph |
tolerance of width error: | ≤±0.05mm/2M |
line speed | 0-30m/min |
area of the whole machine: | 15m(L)x5m(W) |
Production orientation | from left to right |
1. Hydraulic expand and shrink de-coiler
1) structure:four rods mechanical manual adjustment with damping device
2) specification:Φ520max×550.
3) Capacity:3MT (Max).
4) Function: it is used to fix the steel coils and do de-coiling. By using the crane to make the coils on the decoiler and manually expand and shrink is driven by the push of core shaft to tight inner hole of steel coil .The decoiler is equipped with the brake device and adjust manually to make the tension decoiling possible.
2.200×550mm Disc slitting machine
1 )specification of blades100×200×10 Material:9CrSi,(8 pcs will be offered by the seller free and a set of spacers and rubber rings).
2) thickness of processable material:δ=0.1-1mm.
3)width of processable material:B≤500mm.
4)electric motor:7.5KW frequency conversion speed control motor with decelerator.
5) decelerator:JZQ350
6) It is designed with both the active and passive slitting
7) the slitting machine is designed with entry guide device and the scrap winder
8)slitting speed:v=30m/min
9) Function: equipped with the side guide device to fix the sheet and prevent the strips jumping when slitting so that to improve the precision. There are active and passive two kinds of slitting to meet the requirements of different thickness steel possible
3. Scrap winder
4. Storage pit
1) It should be done according to the foundation drawings(according the situation, this can prepared ,also cannot prepare)
4. First pre-dividing,and press device(1 unit)
1) Function: when cutting the thin sheets, it is used to establish the back tension and insure the even and tight quality of recoiler.
5. 508max×550 Recoiler(1unit)
1) Structure: expand and shrink manually
2) Specification of shaft:Φ508max/Φ480min×550.
4.Motor:22KW frequency conversion control motor with decelerator.
5.speed:v=38m/min(average)
6. Function: it cooperates with the first and second dividing device to do the recoiling, make the tension and speed adjustable
6.Electrical control case(1 unit)
1)It controls the speed of the whole line. The main operation table can make the whole line change from high to low speed. And it can also make the plate into the machine manually.
The parts mentioned above composed the whole slitting line, make it function is stable and operation is convenient.