Ads by Google
The connection from the receiver to actuator (relay case) uses network Cat 5 cable. 4 or 8 or 12 lighting circuits can be controlled by the receiver. Multiple receiver scan form a control network using CAN-Bus system. Computers can also be connected to the control network to query information from the receivers or send control commands to them. In this way, a centralized control can be implemented. Receivers may be installed above ceiling or inside electricity distribution box. There are 2 buttons on a receiver, one is used to make the receiver go into learning mode, and the other is used to clean up the learned information. It has the following characteristics:
l Each receiver has a separate microprocessor, is the most advanced distributed control system.
l Various switching modes are supported, such as delay on/off
l The receiver has various control logic built in. Besides lights, it also can provide controls devices like curtain and HAVC.
1.1 Benefitsl Easy installation, easy maintenance
l Support various switching modes
l Up to 4 or 8 or 12 outputs
l Can self-learning IDs of YTL Wireless Sensors
l Control various electric devices. Such as air-conditioning, lighting, curtain.
l Support USB and Networking
1.2 Scope of UseThis product can be used in offices, hotels, schools, homes, factories, hospitals, municipal buildings, and other indoor places.
1.3 Parametersl Norm Conforming Assembly: Q/67218248-4.1-2009
l Power Supply: 100VAC~265VAC, 50Hz/60Hz±1Hz
l Frequency: 315MHz/868MHz
l Operation Temperature: -10°C - 60°C
l Storage Temperature: -20°C - 80°C
l Humidity: ≤95%
l Dimensions: 149mm x 90mm x 60mm
l Output: 4 or 8 or 12 on/off outputs
l Mechanical Data: Flame Retardant ABS
l Protection Type: IP30
1.4 Points for Attentionl The temperature of receiver is -10°C~60°C. Power AC100V~265V, 50Hz/60Hz; Use the product out of the scope may cause abnormal work or damage equipment.
l The product is for indoor use only. Avoid dust, moisture, corrosion.
l The product should be installed and used to the place that is non-shake, non-vibration. The position of antenna should far away from metal and other radio devices or devices generating electric noises
l Avoid electric shock, non-professional people can’t unpack the receiver.
4\8\12 Channel Receiver