Iwill Dip DC Board DC12V120W 1. Power:Max 84W; 2. Size:54.5mm*32.5mm*21.6mm 3. Efficiency:90%

  Iwill DC12V120W Dip DC Board DP101 For S197 Case

  

Specification:

DC Input

 

Input Requirements

 

 

Parameter	Minimum	Nominal	Maximum	Unit
Vin	11.4	12.0	12.6	VDC
Iin			12	A
Ripple & Noise			200	mVp-p

2.2 Efficiency

 

 

The converter efficiency should not be less than   90%   at the maximum load of section 3.1

with nominal DC input voltage specified in section 2.1.

 

 

 

DCOutput

 

 

Output Power Distribution

 

 

 

Output	Load Current (A)			Maximum Combined Power ( W)
	Minimum	Maximum	Peak
+12V	0	4	6	84
+5V	0	4	6
+3.3V	0	4	6
-12V	0	0.1	0.2
+5VSB	0	1	2

 

 

Output Voltage Regulation

 

Output	Range	Minimum	Nominal	Maximum	Unit
+12V	±5%	11.40	12.00	12.60	Volts
+5V	±5%	4.75	5.00	5.25	Volts
+3.3V	±5%	3.14	3.30	3.46	Volts
-12V	±15%	-10.80	-12.00	-13.20	Volts
+5VSB	±5%	4.75	5.00	5.25	Volts

Output Ripple and Noise

 

 The output ripple & noise requirements listed in below should be met throughout

the load ranges specified in section 3.1 and under all input voltage conditions as specified in section 2.1

 

 Ripple and noise are defined as periodic or random signals over frequency band of

10Hz to 20MHz. Measurement shall be made with an oscilloscope with 20MHz bandwidth. Output should be bypass at the connector with a 0.1uF ceramic disk capacitor and a 10uF electrolytic capacitor to simulate system loading.

 

Specification:

 

Output	Maximum Ripple & Noise ( mVp-p )
+12V	120
+5V	50
+3.3V	50
-12V	120
+5VSB	50

Pictures:

Iwill DC12V120W Dip DC Board DP101