Ads by Google
Satelite Finder WIRING AND OPERATION:1.Connect a jumper cable form the LNB/LNBF to the "TO LNB"connection on the Satellite Dinder.2.Conect the cable from your satellite receiver to the "TO REC"input on the Satellite Finder.3.Make sure your satellite receiver is on The Satellite Finder's scale should be lighted at his time and the meter reading shoud be around 2.4.Set your dish to the proper azimuth and elevation settings .(This information should be supplied with your dish.)5.Set the Satellite Finder's scale reading to about 5 by adjusting the lever control found on the face of the Satellite Finder.(Turning the knob clockwise will lncrease the reading.)6.Peak the signal by slowly moving the azmuth and elevation of your dish.If the Satellite Finder's reading becomes full scale,adjust the level contol knob to reduce the reading to around 5. (Turing the knob counterclockwise will deriease the reading.) Continue the move the dish until you have the highest possible meter reading.7.Remove the jumper cable and Satellite Finder and reconnect the LNB/LNBF to your receiver.
IMPORTANT NOTES:1. To avoid a continuous full scale reading ,do not use the Satellite Finder directly in front of the dish.2. When using a LNB/LNBF with gain higher than 60 dB,insert a 5 dB attenuator between the LNB/LNBF and the Satellite Finder.3.(Weight of Antenna)88.1g4.(Dimensions)8.28*3.28*6.49cm
DVB-T TV antenna