1 PCD dies for wire drawing 2 superior quality and performance 3 good wear resistance 4 good finish surface

PCD dies for wire drawing is polymerized with synthetic diamond single crystal, adding a small amount of silicon, titanium and other binding agents, under conditions of high temperature and high pressure.

 

 

 

PCD dies advantage:

good wear resistance, uniform bore, strong impact and high wire drawing efficiency, and the price is much cheaper than natural diamond wire drawing die. PCD dies is widely used in wire drawing industry. Used for aluminum wire, copper wire, stainless steel wire, alloy wire etc..

 

PCD dies specification

size range		tolerance	casing ref. Size
inch	mm	mm	mm
≤0.0008	≤0.020	0.0006	Φ25×6
0.0008 – 0.0019	0.020 – 0.050	0.0006	Φ25×8
0.0020 – 0.0039	0.051 – 0.100	0.001	Φ25×8
0.0040 – 0.0079	0.101 – 0.200	0.001	Φ25×8
0.0080 – 0.0199	0.201 – 0.500	0.0015	Φ25×8
0.0200 – 0.0399	0.501 – 1.000	0.002	Φ25×10
0.0400 – 0.0590	1.001 – 1.500	0.0025	Φ25×12
0.0591 – 0.0866	1.501 – 2.200	0.003	Φ25×14
0.0867 – 0.1299	2.201 – 3.300	0.004	Φ28×16  Φ30×16
0.1300 – 0.1810	3.302 – 4.600	0.005	Φ28×18  Φ30×18
0.1811 – 0.2164	4.601 – 5.500	0.006	Φ43×26
0.2165 – 0.3150	5.501 – 8.000	0.008	Φ43×30

	soft wire	hard wire
entrance angle	70+/-20	60+/-20
reduction angle	16+/-2	14+/-2
bearing length	25-50%	40-80%
exit angle	15+/-5	15+/-5
back relief angle	50+/-20	50+/-20

soft wire: copper wire, aluminum wire, brass wire, gold wire etc.

hard wire: stainless steel wire, copper plated steel wire, tungsten wire etc.

Export to Europe and US with good price - PCD Dies for wire drawing