Ads by Google
Product Features:
3 watt super-brightness LED lighting High-power and high-efficiency generator Variety of lighting modes for choiceBuilt-in high-efficiency boost circuit that is suitable for charging most of mobile phones, especially for IPHONE and other Smartphone .No special adapter cable is needed ,and cell phone data cable will be applicableBuilt-in charging management circuit, which can effectively extend the lithium battery life Built-in battery status display function
Lighting Function:Press the button for one time, the light indicator is on, and turn on the lighting lamp.If Press the button again in two seconds, the SOS function would be turned on, otherwise it will exit directly, which is same operation for Flash/Out Once the built-in battery is full, it could light for two hours continuously. When the power is low, you can rolling the handle for generating the power for lighting.
Charge the built-in Battery Two ways to charge the build-in lithium battery By rolling the handle the built-in generator will charge the lithium batteriesCharge the built in-lithium battery by using computer USB interface or power adapter through a wire of the USB that has two interfaces on each side.In the charging process, 4 LED indicators light will rotate an light on when fully charged. About 1.5 hours’ continuous charging can make the built-in battery full.
Inspect the status of Built-in Battery Press the button for about 1 second, then loosen the button when the lighting lamp is on, At this moment, the status of battery would be displayed. If all the 4 LED lights are on, it indicates that the battery is full ,If 3 LED lights are on, it indicates that the battery voltage is in the normal range, while if 2 or 1 light is on, it shows that the voltage is quite low ,it means that the battery is under voltage condition, it can be used by only charging immediately.Charge the Mobile Phones Connect the data line of cell phone to the USB port of this charger, then press the button for four times, when the OUT indicator would light on , it will charge the cell phone. If the power of the built-in battery is low, you can continuously roll the handle to generate power, then can charge your mobile phone. For Apple Iphone or other Smart phone, 1 minute charging could make the phone stand by 2 hours or talking 5 minutes. For non-smart cell phone, 1 minute charging could keep conversation for about 10 minutes and standby for 5-10 hours.Note:When the built-in battery is fully out of power, it could begin to display the charging status normally after charging it for about ten seconds. Try to maintain a constant speed when rolling the handle and too much force is easy to reduce its service life. Approximately roll about 1.5 circles every second
3W high-power high-brightness LED Dynamo flashlight