Anti-static floor

The HPL Type Access Floor system is composed of panel, pedestals and stringers and screws. The stringers and pedestals that are vertically adjustable are connected with screws, which forms the stable bottom bearing .The panel is inlaid in the square lattices.

1) Panels

Brief: Panel consists of a 600mm by 600mm. The bottom tray has sixty-four 62mm diameter by 21mm deep hemispherical dimples pressed into it.

Fabricated with die-cut flat top sheet and die-formed and stiffened bottom pan formed good quality cold- rolled steel sheet joined together by 100 resistance welds every 67mm to form an enclosed assembly, and coated with epoxy powder after having been phosphoreted to protect against corrosion and then filled internally by a lightweight cementitious meterial. The surface is stuck with anti-wear and fireproof high pressure laminate (HPL) tile. The borders are trimmed with conductive rubber edges.

a.      Panel Size:600*600*35mm b.       HPL finish: HPL are manufactured through high temperature and high pressure by impregnated melamine paper and phenolic paper. It’s colorful, flatness, with properties of wear-resistance, heat-resistance, dirty-resistance, clearance maintainance and permanent decoration etc. It is widely employed in Data Processing Departments, in computer rooms, laboratories and any room where cleaning, ease of maintenance and wear resistance are required. 

Technical Characteristics:

Thickness:	1.2mm
Weight Density:	1450Kgs/mP3P
Abrasion Resistance:	>3000 REV.
Fire Rating :	Class A
flammable fire hazards	<10S(GB4609-84)
Electric Resistance:	10P6P-10P10 Pohm

c. Type: FS1000

Reference to CISCA A/F Section II:

Concentrated Load	Apply load (lbf)	Bottom surface deflection(mm)
Center point	1000	1.7mm

Bottom surface permanents set: 0.2mm

Ultimate Load	Apply load (lbf)	Observation
Center point	3800	The panel wasn’t broken after test

d. Weight: approx. 14.8Kgs/pc 

e.  Panel is fabricated from completely non combustible materials.

2) Understructure

A. Flat head steel pedestal

a. Pedestals finished floor height: FFH=100cm

b. Pedestal Base at 120*120*3mm thick steel plat. 4 screw holes, one at each corner.

c. Pedestals with flat steel head, carried by a leveling nut on threaded M18 solid steel column, with provisions to prevent vibration displacement of the leveling nut, inlaid in the 38mm diameter circinal tube.

d. Pedestal head size: 75mm *75mm *3mm

e. All understructure are in silver galvanize to prevent corrosion damage.

B. Stringers

a. Size: 30*21*1mm thick

b. Length: 570mm

c. All understructure are in silver galvanize to prevent corrosion damage.

Raised full steel anti-static flooring for dataroom