reasonable prices, high production capacity, product uniformity, low energy consumption per unit

Hammer crusher for crushing all kinds of hard and abrasive weak materials. The compressive strength of the material does not exceed 100MPa, water content less than 15%. Material to be broken coal, salt, chalk, gypsum, brick, limestone and so on. Also used broken fiber structure, strong flexibility and toughness of broken wood, paper or broken asbestos cement waste to recover asbestos fibers and so on. In addition, the hammer crusher for crushing not only the production line, sand production line, can also be replaced in the mineral processing production line cone crusher. Hammer Crusher is the main working parts with a hammer (also known as hammer) of the rotor. Rotor from the spindle, disk, composed of pin and hammer. Cavity in the broken rotor motor driven high-speed rotation. Material from the upper mouth to feed into the machine, by the high velocity hammer blow, impact, shear, abrasive and grinding. The lower part of the rotor, with sieve plate, crushing the material in grain size smaller than mesh size sieve discharged through the larger than coarse mesh size in the sieve retention continue to be a hammer blow on and grinding, and finally through the sieve board outside the crusher discharge.

model	Rotor diameter	Working length of the rotor	Rotor speed	Into Granule	Fineness	production	motor power	weight
	(mm)	(mm)	(r/min)	(mm)	(mm)	(m3/h)	(Kw)	(kg)
SCP400×300	400	300	1200	≤80	≤10	5-8	11	700
SCP600×400	600	400	1000	≤100	≤15	10-15	18.5-22	1500
SCP800×600	800	600	980	≤120	≤15	20-25	55	3700

Hammer crusher