Industrial Pneumatic Transport Pump 1.Body Inner Diam:800-24000 mm 2.Total volume:0.35-9.25 L 3.Max.conveying distance:1500 m

Industrial Pneumatic Transport Pump System for Coal Powder or Cement Plant

Industrial Transport Pump System Operating Modes:

Materials in the storehouse are into storehouse pump under gravity, during this time, the discharge valve and the intake valve is closed while Pneumatic sealing valve, close calve and exhaust valve  open, so ensure the material into the storehouse pump smoothly. 

Level indicat-or send electrial signals to PLC controller when the materials reach a certain  position in pump, then PLC controller convert electrical signals into valve signal,at the same time, exhaust valve closed, sealing valve, closed valve, vent valve open, after the pressure in storehouse reach a certant extent, signal is sent to PLC controller by pressure transfitter, with that send to discharge valve after PLC convert it into electrical signals.

Open the discharge valve, materials into pipe with low flow, high density by air flow. Period finished, pressure in storehouse pump and pipe drop to zero.

Industrial Pneumatic Transport Pump Specification:

Parameters	L-0.8	L-1.2	L-1.4	L-1.6	L-1.8	L-2.0	L-2.2	L-2.4
Body Inner Diam.(mm)	800	1200	1400	1600	1800	2000	22000	24000
Total volume(m3)	0.35	1.32	2.15	3.0	4.12	5.0	7.5	9.25
Operation Temp.(°c)	≤120
Max.design pressure(Mpa)	0.78
Operation Pressure(Mpa)	0.2-0.5(Basis on the conveying disance and conveying material)
Body materail	Q235-B
Max.conveying distance(m)	500~1500M
Outlet conveying Diam	DN50	DN100/DN125					DN125/DN15
Mixing ratio	50	60	60	60	60	60	70	70
Capacity(t/h)	5	12	20	25	30	35	45	55
Air consumption (m3/min)	2	6	6~10		10~20		16~20