Welcome to ECOL - Join Free - Sign In
rechargeable and waterproof bicycle laser rear light
rechargeable and waterproof bicycle laser rear light
Supplier Info
[China Supplier]
Contact Person : Ms. Guo Rose
Tel : 86-0769-33358234
Fax : 86-0769-81181256
Product Detail
1.rechargeable and waterproof, 2. 8LED+2 laser diode,continuous working 6-8h; 3. R/G/B/W 4 COLORS; 4.Visible from over 1km;

Introduction of Bicycle Laser Tail Light

1.Introduction of Use

        As to the city roads become more and more complex,along with the bicycle enthusiasts quantity is daily up, safely riding is concerned by the peole who are busy working during the day and riding at night. So our low carbon,pro-environment, rechargeale and water-proof tail light which just like a diamond is born.

      With more promotion on the design and practicability,it inproves the dim field of vision.There are not only 8 high brightness LED lights to complete 3 shining ways,but also 2 laser lights at a 120 degree angle project two parallel lanes to increase the safety in rain and fog weather.And it has isolated charger and natual reflective lampshade,longer continuous working hours,these can double insure you riding safely.

2.Specification

Article: Bicycle laser tail/rear light

Shell Color: Red,green,blue and white,other colors can be customized.

Power Supply: Input 100-240 VAC   50/60 Hz   0. 5 A

             Charge voltage 4.2-5VDC-500 mA

Battery: 14500 rechargeable battery, capacity 1200 mAh, voltage 3.7V

Work Time: continuous wok time ≥6hours

Charge Time:3-5hours(Note:when the charger warning light is red, it shows charging state;when is green,shows completed)

Laser Color: 658±5 nm(red color)

Laser Light Power: ≤5 mW

Package Dimension: L210mm×W145mm×H45 mm

Total Weight: 0.2Kg

Note:As to its battery protected unit,if over charged,this unit will shut down to protect the battery(that is take out the charger,the tail light off,if plug in ,it is on).the You can plug in it again for 1-3 seconds and then take it off to solve.

3.Introduction

 1).Installatin

Place the nut into the fasteners and install the rubber strips to control the tightness, then place the carriage into the nut hole,tight the nut.(not need the screw driver,convenient and fast)

2).Operation

The light has 8 LED in body and 2 LD at its side,they are isolated controled but same operation. once,slow shining;twice,fast shining;third,normally on,press again,it is off.

4.Package

A bicycle laser light,a piece of USB data line,a 3.7v charger,2 rubber strips,a bracket,a circle,a plastic bags screw,a nut.

5.Others

 

Ads by Google

Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2022 ECOL Limited and/or its subsidiaries and licensors. All rights reserved.