Hotmelt Adhesive for Steel Wire Pipe
Product introduction
1.This product applies to the steel wire reinforced hdpe composite pipe, which consists of a steel wire reinforcement layer between the inner & outer PE layer and is composited into one through extrusion molding technique with the special purpose hot melt adhesive.2.The hot melt adhesive could mix with polyethylene resin for use. It has superior advantages of high adhesive strength, good thermo stablility and lower cost.3.Processing technique of the hot melt adhesive is as same as that of common polyethylene, thus it has good operability and simple requirements on the equipments.4. This product does not affect the technical performances of other materials when mixed together in use.
Physical Property Index
Physical Property | Unit | Standard Value | Test Value | ||||||
Melt flow rate | g/10min | 1.5-3.5 | 1.66 | ||||||
Tensile strength | Mpa | ≥16 | 19.11 | ||||||
Elongation at break | % | ≥500 | 550 | ||||||
V-cat softening temperature | °C | ≥120 | 121 | ||||||
Brittle temperature | °C | ≤-50 | -54 | ||||||
Peeling strengh | N/cm | ≥100 | 270 |
All test values shown in above form come from our genuine experiment. The values are just for reference and do not act as data of formal quality commitment.
Packaging, Transportation and Storage
1. The product is packed in plastic and paper compound bags (moistureproof plastic bag inside), 25kg/bag | |||||||||
2. Touching with organic solvent should be avoided in transit. | |||||||||
3. This product should be stored in dry and ventilated places. Touching with organic solvent shall be avoided. It should be kept away from fire source or any material which is easy to create sparks. | |||||||||
4. The product left unused in a unpacked packaging should be resewn up or repacked with other packaging in order not to be damp and polluted under long time bareness. |
Hotmelt Adhesive for Steel Wire Pipe