300m wireless ap router 1.AR9331/openwrt 2.40.5*27.5 mm 3.4Lan,1Wan 4.64MB RAM

300m wireless ap router

The GS-Oolite V1.2 is marketed as a "3G travel router". It does not include a 3G modem - it simply means that the OEM firmware supports USB 3G modems, and that the oem firmware contains drivers for USB modems! Ridiculous, since with OpenWrt ANY router with USB supports 3G hardware. 

The device is very similiar to the TL-WR703N  TL-MR3020.

Features Atheros AR7240 CPU (400Mhz)Atheros AR9331 Chipset (integrated wireless)802.11 b/g/n 150Mbps (130Mbps real)wireless power output 20dBm - 100mW4/8/16 MB flash memoryDDR2 64 MB RAMUSB 2.0 port

I2S audio interface

Tiny form factor: 27.5 * 40.5MMUSB: Usb 2 master interface, support USB hub extension

4LAN ports and 1 WAN port

 Pin Description1 GND GROUND2 ANTENNA Customer can select connection point, top or side3 GND GROUND4 SPI_MOSI SPI serial interface5 SPI_CLK SPI serial interface6 SPI_MISO SPI serial interface7 RESET_CONFIG resets the firmware to its default configuration when pushed8 LED6 WLAN LED9 LED5 LAN_PORT3_LED10 LED4 LAN_PORT2_LED11 LED3 LAN_PORT1_LED12 GPIO_22 KEY_INPUT13 GPIO_23 KEY_INPUT14 LED2 LAN_PORT0_LED15 LED0 Wireless LED16 UART_RX (SPI_CS1) Serial data in17 UART_TX (SPI_CS2) Serial data out18 GND GROUND19 GND GROUND20 WAN_PORT_RX+ Ethernet port21 WAN_PORT_RX- Ethernet port22 WAN_PORT_TX+ Ethernet port23 WAN_PORT_TX- Ethernet port24 LAN_PORT3_TX+ Ethernet port25 LAN_PORT3_TX- Ethernet port26 LAN_PORT3_RX+ Ethernet port27 LAN_PORT3_RX- Ethernet port28 LAN_PORT2_RX+ Ethernet port29 LAN_PORT2_RX- Ethernet port30 LAN_PORT2_TX+ Ethernet port31 LAN_PORT2_TX- Ethernet port32 LAN_PORT1_TX+ Ethernet port33 LAN_PORT1_TX- Ethernet port34 LAN_PORT1_RX+ Ethernet port35 LAN_PORT1_RX- Ethernet port36 GND GROUND37 VDD_3.3V 3.3V input 1000mA38 VDD_3.3V 3.3V input 1000mA39 VDD_2.0V OUTPUT Power supply output for peripheral network transformer40 GND GROUND41 LAN_PORT0_RX+ Ethernet port42 LAN_PORT0_RX- Ethernet port43 LAN_PORT0_TX+ Ethernet port44 LAN_PORT0_TX- Ethernet port45 USB - USB signal, carries USB data to and from the USB 2.0 PHY46 USB + USB signal, carries USB data to and from the USB 2.0 PHY47 LED8 JUMP START LED48 JUMPSTART (UART_RTS) KEY_INPUT

 

it's design for wifi hard disk, WiFi router, remote monitoring, remote video, Industrial control DIY and so on

300m wireless ap router