Ads by Google
Air Tools Trouble Shooting:
| Air tools runs at normal speed, but loses under load | Motor parts worn Cam cluth worn or sticking due to lack oflubricant | Lubricating clutch housing. Check for excess clutch oil. Clutch cases need only be half full Overfilling Can cause drag on high speed clutch parts,is a typical oiled/lubricated wrench requires 1/2 ounce of oil |
| Air tools runs slowly, Air flows slightly from exhaust | Air tools's motor parts jammed with dirt particles Power regulator in closed position Air flow blocked by birt | Check air inlet filter for blockage. Pour air tools lubricating oil into air inlet as per instructions. Operate tool in short bursts quickly reversing rotation back and forth where applicable.Repeat above as needed.Air |
| Air tools will not run, Air flows freely from exhaust | One or more air tools's motor vance stuck due to material build up | Pour air tools lubricating tool into air inlet Operate tool in short bursts of forward and/or reverse rotation where applicable Tap motor housing gently with plastic mallet Disconnect supply. Free motor by rotating drive shank manually where applicable |
| Air tools will not shut off | Air tools's "O" rings throttle valve dislodged from seat inlet valve | Replace air tools's"O" ring |
Showroom:
Certificate :
Air Tools Packaging And Equipment:
Description :
Air Tools Kits RP7820
20pcs Air Tools Kits Contents:
1pc 1/2" Air Impact Wrench 1pc 3/8" Air Ratchet Wrench
1pc 1/2" Ratchet Air Hammer
1pc Ratchet Die Grinder
1pc 1/4" Die Grinder
1pc 1/4" Air Angle Grinder
4pc Hand Wrenches
1pc 4mm Hex Key Wrench
4pc 25mm Chisels(round)
1pc Chuck Key
1pc Male Nipple .
1pc Oil Pot
1pc Emery Wheel
1pc Blow Mould Case
RongPeng Air Tool Kits -RP7820