Welcome to ECOL - Join Free - Sign In
temperature resistant EPS lines
temperature resistant EPS lines
Supplier Info
[China Supplier]
Contact Person : Mr. Wu Henry
Tel : 86-21-57800066
Fax : 86-21-57803636
Product Detail
1.saving-cost,high durability 2.lightweight,easy to carry 3.a green product,save 85% of material temperature resistant EPS linessimple introduction:The product is EPS expanded polystyrene plate cutting according to size and shape, and wipe the special mortar alkali mesh cloth to form a protective layer. It is a new type of exterior decorating line, and it is the alternative of traditional cement component (GRC). It has the features like simple and quick construction, convenient design, short cycle, light weight and other characteristics. It can design a variety of shapes, styles flexibly.Construction Points:1,According to the construction drawings, draw the positioning line(center line or edge)at the place to fix the EPS component.2,When pasting the EPS, the mesh should be turn and pack, or it can pasting only in the special circumstances. Press the EPS component to make the mortar flow out, and make the gap narrower than 3mm. The gap should be full and keep the EPS component surface clean.3,For the bigger EPS component, it need to be temporary fixed at the installation.4,If it need to splice, it should be assembled well in advance the size and angle measurement, and pre-assembled in the smooth place, the gap is not greater than 3mm. Bonding materials for the splicing adhesive mortar, the mortar consisitency can be little bigger. Splicing need to even squeezing and hammering to meet the requirements of the mortar joint.5,An application of gray mortar joint should be flat by the knife so that EPS components into one. After drying, if the EPS component patchwork excess adhesive mortar can be left by sandpaper7,You should pay attention to the EPS product protection, it is strictly prohibited heavy impact. If damaged, you should reinstall the entire EPS components.  NOTES:1,The construction environment temperature should not exceed 38°C, not less than 5°C, wind is not more than 52,Before the installation and cutting of the EPS component, the wall does not need to watering. Dust, dirt and other debris should be cleaned3,The assembly joints are advised to stay in the middle of the EPS component4,Bonding EPS components, add the recommended amount of water to the mortar. But, splicing the EPS components, the recommended amount of water in 1~2%5,Just bonded EPS components should pay attention to maintenance, to prevent rain erosion, and personal damage.g

temperature resistant EPS lines

Ads by Google

Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2022 ECOL Limited and/or its subsidiaries and licensors. All rights reserved.