It is applicable for two reinforcing fillets being formed on the both sides of vacuum tube hole in the water barrel of solar wat Solar Water Tank External Barrel Press Mortising Machine  Product Introduction:     

It is applicable for two reinforcing fillets being formed on the both sides of vacuum tube hole in the water barrel of solar water heater and keeping these vacuum tube holes of inner-barrel in the same horizontal line so as to enforce them by two to three degree against tube hole variation during the operation or pressing trace about the break. It is advanced in the many aspects, such as no special mould being usage, lower usage cost, easy installation and operation and high flatness.

 

Product Features:

1. This equipment is welded by steel plate and other kinds of steel.

2. It through the air compression and the cylinder lift to produce fluctuation pressure power.

3. The workbench uses the simple locking latch, fastens the work bedplate to the operating position tightly in 4. the work hours and loosens the locking latch at the end of the work, and then extracts the work pieces.

5. When using the equipment, people should fasten the fold plates through both sides of the cylinder tightly, and then start the pressure tenon machine to compact the edgefold from the front to the back for the docking purpose.

Technical specification

Model specification	Rated voltage	The power rating	Comprssed air
L1500/L2000/L2500/L3000/L3200mm	380V	1.5 KW	0.25-0.6Mpa

Solar Water Tank External Barrel Press Mortising Machine