Obstruction light for a wide variety of cranes used in Harbors, Metallurgies, Towers (Telecom, GSM), Smokestacks, Buildings

Main fuctions and features:

•  Use Fresnel lens, high utilization of light, valid keeping light beam in the scope as required

•  Based on LED technology, low power consumption, and high effecience

• Die casting aluminum enclosure with powder-coat paint finishes, providing corrosion resistance and durability

•  Extremely Reliable – Major Maintenance Cost Saving

•  G3/4”pipe is available, ease of mount

•  EMC Compliance, No RF Radiation

•  Self-contained compartment, with stainless steel wire which is used to secure the unit against falling in operation, and ease of mount

•  Lamp housing – Polycarbonate, with good anti-impact strength, thermal stability, high transmittance

•  Built-in photocell can switch ON/OFF the light at dawn and dusk (optional)

•  Steady burning or flashing type (no need external controller).

Specification 

Standard	Compliant to the ICAO(Aerodromes Annex 14) and FAA-L810	Vertical degree	≥10
Light source	LED	Horizontal degree	360
LED color	Aviation red	Flashing rate	Steady burning or flashing(flashing rate can be selected)
Operating voltage	AC110V~AC240V(Option:DC48V)	LED life	≥100,000h
Power consumption	6W	On/off level	500Lux
Intensity	≥32.5cd
Operating temperature	-30C ~ +70C	IP Protection	IP65
Relative humidity	10% ~ 95% (no condensing)	Weight	1.0kg
Material	Base:Die casting aluminum, housing: PC

Installation and operation

•  Check whether the supply voltage does comply with the rated voltage of the lamp (Pay attention to the polarity in case of DC voltage).

•  Insert the power cable through the bottom of lamp holder, and connect them to the terminals in the base respectively

•  Select the flashing mode as required 

•  Tighten the screws between lamp housing and base

•  Screw the lamp on the G3/4” ( G1”) threaded pipe, which should be fixed on a smooth surface with enough mechanical strength. Or you can select our mounting bracket: PJ024, PJ028 and PJ030 (installing diagram), special bracket can be customized.

•  Verify whether the power cables are well connected before power on.

Wiring diagram

                       

     

Wiring diagram for DC power                   Wiring diagram for AC power

Installing diagram

   

           LS710+PJ024                               LS710+PJ028

LS710+PJ030

navigation aids/warning light/warning lamp/side red light/side green light/top light factory