Welcome to ECOL - Join Free - Sign In
combine gsm gps antenna with MCX and FME connector
combine gsm gps antenna with MCX and FME connector
Supplier Info
[China Supplier]
Contact Person : Ms. Yin Nancy
Tel : 86-755-27579205
Fax : 86-755-27579184
Product Detail
gsm gps dual antenna gps1575.42mhz gsm850,900,1800,1900mhz cable:RG0.81,RG1.13or other connector:SMB,MCX,MMCX,Fakra or other

Electrical Characteristics

3.1 Dielectric Antenna

Form 1

No.

Item

Specifications

Post Environmental Tolerance

1

Center Frequency

1575.42 MHz

+-3 MHz

2

Band Width

+-5 MHz

+-1 MHz

3

V.S.W.R(in BW)

1.5 /1

4

Gain(Zenith)

3 dB

+-0.5 dB

5

Polarization

RHCP

6

Impedance

50

 

3.2 LNA/Filter

Form 2

No.

Item

Specifications

Post Environmental Tolerance

1

LNA Gain

28+-2 dB

+-2.5 dB

2

Noise Figure

1.5 dB

3

Filter Out Band Attenuation

12dB  Min  f0+50MHz

16dB  Min  f0-50MHz

+-1.0 dB

4

DC Voltage

2.2~5 V

5

DC Current

5~15 mA

 

3.3 GSM Antenna

 Form 3

No.

Item

Specifications

1

Frequency

824~960 MHz/1710~1990 MHz

1920~2170 MHz

2

V.S.W.R(5m)

2.0/1

3

Gain(Zenith)

2 dBi

4

Impedance

50

 

3.4 Mechanical

Form 4

No.

Item

Specification

1

Cable

RG174/RG58 30CM

2

Connector

SMA

3

Plastic Housing

Black

4

Mounting

Screw

4.Reliability

Condition  Temperature: 40+-5 degree C 

Load  DC=5V+-0.5 V

Quantity   2000pcs 

Sustained Time    480h 

5.Environmental Specifications

Post Environmental Tolerance (Refer to the form 1~2 ) 

Condition  Temperature range 25+- 3degree C

Relative Humidity range 55~75%RH

Operating Temperature range -40degree C~+85degree C 

Storage Temperature range -40degree C~+100degree C 

5.1 Moisture Proof 

The device should satisfy the electrical characteristics specified in form 1~2 after exposed to the temperature 40+-2degree Cand the relative humidity 90~95% RH for 96 hours and 1~2 hours recovery time under normal condition. 

5.2 Vibration Resist 

The device should satisfy the electrical characteristics specified in form 1~2 after applied to the vibration of 10 to 55Hz with amplitude of 1.5mm for 2 hours each in X , Y and Z directions. 

5.3 Drop Shock 

The device should satisfy the electrical characteristics specified in form 1~2 after dropping onto the hard wooden board from the height of 30cm for 3 times each facet of the 3 dimensions of the device. 

5.4 High Temperature Endurance 

The device should satisfy the electrical characteristics specified in form 1~2 after exposed to temperature 80+-5degree C for 24+-2 hours and 1~2 hours recovery time under normal temperature. 

5.5 Low Temperature Endurance 

The device should also satisfy the electrical characteristics specified in form 1~2 after exposed to the temperature -40degree C+-5degreee Cfor 24+-2 hours and to 2 hours recovery time under normal temperature. 

5.6 Temperature Cycle Test 

The device should also satisfy the electrical characteristics specified in form 1~2 after exposed to the low temperature -25degree C and high temperature +85degree C for 30±2 min each by 5 cycles and 1 to 2 hours recovery time under normal temperature. 

 6.Weatherproof

Put the antennas in 1m deep water for 12h, and find 100% waterproof.

 

Ads by Google

Hot Products: A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | 0-9
Copyright Notice @ 2008-2022 ECOL Limited and/or its subsidiaries and licensors. All rights reserved.